- General: Furnish conveyor and equipment substantially as described. All equipment will be manufactured from prime quality material and produced in a workmanlike manner. All conveyors will be match marked prior to shipment. Component sections will be securely skidded for shipment via common carrier.
Construction: Formed with 11Ga. stainless steel with T304 #3 polished surface.
Splice Plates: Conveyor will have top or side splice plates.
Table Top Chain Supplied by FLC will be Tab style chain. Plastic chain design thickness for LF882 and LF831.Chain to chain transfers will be less than 1/8”, preferably 1/16” to 3/32”
Table Top Sprockets: 12 Tooth for side-flexing chain, 25 tooth for straight run chain. Idlers will not be mounted on a shaft that does not rotate.
Shafting: 1-1/4” diameter Stainless steel.
Power Transmission: #50 RC chain coupled where possible
Bearings: Two-bolt flange white plastic housing type with corrosion resistant bearing inserts.
TT Chain Return: Serpentine or roller supports. No solid pans will be used
Wear strips: UHMW/PE slipped over stainless steel bar. Raised platform style.
Curve Wear strips: UHMW/PE.
Guiderail: 1-1/4” Tee Rail UHMW/PE with stainless steel sheath.
Curves to have adjustable vertical extension brackets.
Guiderail Brackets: Stainless steel 1-1/2” x 3/16” with 3 ft. or less spacing.
Supports: Stainless steel 1.5 square tubing with +/- 2 ½” adjustment.
Drives: 1.5HP Reliance Motor with 262 Dodge Gear Reducer
Elevation: 48” Per layout drawing +/- 2-1/2”.
Electrical: 460/230 volt, 3 phase, 60 hertz
Speed: Tables 10 – 60 FPM
High speed single line 100 – 260 FPM
Adjustable Feet: Adjusting screw with locking nut for height adjustment. Provisions for feet to be lagged down.
Provide CAD drawing showing match mark numbers.